HBD K8 Retractable Bollards

 

 

 

Technical Features

Crash / Impact Rating Crash tested and certified according to ASTM F2656-07 at M40 (K-8) level (HBD 275 H 90). In addition, designed and produced to withstand impacts mentioned below:

Standard                                  Vehicle Type                                 Weight                                     Speed
PAS 68                                            N3                                            7500 kg                        64 km/h (40 mph)
IWA 14-1                                        N3C                                         7200 kg                        64 km/h (40 mph)
(Please contact for applicable product dimensions).

 
Optional Features and Accessories Hydraulic accumulator for EFO-fast raise up, 24V DC motor in case of power failure (min. 60 – 100 movements), oil heater (for oil tank), oil cooler, heater for electronic components, submersible pump, traffic light (Ø200/300 mm, red-green LED, electrostatic powder coated over 304 grade stainless steel body), traffic light pole (electrostatic powder coated over hot dip galvanised steel), loop detector (double contact), safety sensors (with 50 cm height poles), IP67 box (for PLC, SMPS, connectors etc inside power unit), wireless remote control (receiver and transmitter), external buttons, PLC with diagnostic display, different product dimensions, 304 – 316 grade stainless steel sleeve.

 
Installation Installation with C30 grade concrete and steel rebar reinforcement. Ground levelling and preparation works shall be carried on before pouring the concrete. Allowable bearing value of the ground shall be minimum 1/2 kg/cm2, if not, works shall be carried on to fulfil.
Installation shall be done according to the manufacturer’s instructions. Possible to install multiple bollard posts controlled by a single hydraulic power unit (HPU). 1200 mm gap between bollard posts in multiple unit installations is recommended.